MFJ: MFJ-856
I have RFI, now what– Locating it
This allows me to verify I am working with the same RFI source. I record the audio from the FT-900, and then I can play it back into Spectrum labs, and see if it matches the RFI I am hearing at home. Once I have a match, I know without a doubt I have the same source. I then look at the map, and it becomes pretty obvious where the RFI is most of the time. I next start running the frequency up as high as possible and still hear the RFI. I then grab a Google Map of a smaller area, around where the signal is strongest, and do the drive around again. I repeat this process moving ever higher in frequency. Continue reading
Review of the MFJ-856 Directional Noise Finder W/ 3 El. Beam
Overall it was useful to me in locating a few sources of RFI, you point it in the general direction of a noise source, and wave it around until you get a peak in the meter. Once you have that, you walk towards the source, waving the antenna around, following the peaks.
The device is reasonably well constructed, MFJ quality control seems to be good, as the unit I got has no defects in it. It came boxed nicely, and was simple to construct. There were a few items to note… Continue reading
